The MXLADC9 is a very low power 9-bit ADC
implemented in CMOS technology. The ADC only consumes 1 mA of current during full speed operation (1us conversion time), while the accompanying BGR and reference block consumes 0.8 mA. It is implemented in CMOS process for easy integration....view full
The MXL-AMUX4 is a self-contained four input
analog multiplexer with typical on-resistance of 50 Ohm. The multiplexer routes one of the four input signals (IN0, IN1, IN2, and IN3) to the output pin (OUT) when the enable input (EN) is set to a logic level 1.
Two select pin (S0, S1) determines which input signal is routed to the output pin. The analog input signals can be rail-to-rail, thus allowing high dynamic range operation through the multiplexer. Due to its small size, the MXL-AMUX4 cell is useful for various applications, such as routing different input signals into an analog to digital converter. Internal control logic guarantee ÃÂbreak before makeÃÂ to avoid input shorts....view full
The MXLBGR1 is a CMOS Bandgap reference
implemented in digital CMOS technology. It generates the bandgap reference voltage as well as reference currents. The reference current can be either referenced to an on-chip resistor, or an external resistor depending on the required current accuracy. The number and values of the output currents can easily be programmed....view full
The MXLBGRLV is a CMOS Bandgap reference that can
operate from a power supply as low as 1V. It is implemented in digital CMOS technology and generates a reference voltage that is temperature, process, and power supply independent as well as reference currents. The reference current can be either referenced to an on-chip resistor, or an external resistor depending on the required current accuracy. The number and values of the output currents can easily be programmed....view full
The MXL-LVDET is a self-contained a Power
management IP that incorporates sophisticated dual
power supply detection circuitry. The two power
supplies are nominally 1.8 V and 3.3 V. This
LOW VOLTAGE DETECTOR block also
provides an un-buffered BandGap voltage output
and a one uA source current reference output. It
also generated a VOK output that, when high,
indicates that both input voltages are within the
specified valid ranges. Mask programmable
resistors are provided for adjusting the center of
the trip point by +/- 10%...view full
You need to either login or register as a buyer or seller to view more IP information
